JetPrime Side Stand Switch Eliminator – Ducati Panigale 1199/R/S (2012-2017) JP ES 011

Engineered from the ground up for race use, the JetPrime JP ES 011 side stand switch eliminator for the Ducati Panigale 1199/R/S delivers a precision-matched, plug-and-play solution that bypasses the side stand switch and simultaneously suppresses the dashboard fault code — no cable cutting, no guesswork, no compromise on build integrity.

Key Features

• Bypasses the side stand switch completely, allowing unrestricted operation on track without the switch circuit interfering with ignition or gearchange logic.
• Eliminates the dashboard error that is triggered when the side stand switch is removed or disconnected, keeping the instrument display clean and fault-free.
• OEM-specification connector included for a direct, secure connection into the factory loom — no splicing, no soldering, no permanent modifications to the wiring harness.
• Premium-grade components selected for long service life and consistent reliability under race conditions.
• Designed and validated specifically for the Ducati Panigale 1199, 1199 R and 1199 S across the full 2012–2017 production run.

Build Quality and Materials

Where generic eliminators rely on loose wire tails and generic connectors, the JP ES 011 is built around an OEM-matched plug that mirrors Ducati's own connector geometry and pin layout. The result is a connection that sits flush in the factory socket with zero play, maintaining the electrical integrity of the original loom. Every component in the circuit is rated for the voltage and current demands of the Panigale's ECU environment, so there is no risk of voltage drop or intermittent faults corrupting sensor data. JetPrime's manufacturing process applies the same quality controls used on its performance electronics range — this is not a cost-reduced bypass resistor in heat-shrink; it is a purpose-built module with the tolerances to match.

Installation and Race Use

Installation is genuinely tool-free for the electrical side: locate the side stand switch connector, unplug it from the switch, and plug in the JP ES 011 in its place. The OEM connector ensures it clicks home first time with no adaptation required. Because no wires are cut or permanently altered, the modification is fully reversible should the bike need to return to road-legal specification. On track, eliminating the switch removes a common source of unexpected cut-outs during aggressive cornering where the switch plunger can bounce on rough surfaces. The simultaneous fault suppression means the dashboard remains clear so the rider can focus on the data that matters — lap times, fuel load, and traction control settings — rather than chasing ghost fault codes.

Fitment and Compatibility

This eliminator is designed and tested exclusively for the following models:

• Ducati Panigale 1199 (2012–2017)
• Ducati Panigale 1199 R (2012–2017)
• Ducati Panigale 1199 S (2012–2017)

Always confirm the connector type on your specific bike before installation. Not compatible with the 1299, V4, or earlier 848/1098 platforms.

Important Notice

The JetPrime JP ES 011 is intended exclusively for motorsport and closed-circuit race use. It is not approved for use on public roads. Fitting this product to a road-registered vehicle may render it non-compliant with road traffic legislation.

Specifications

• Brand: JetPrime
• Part number: JP ES 011
• Type: Side stand switch eliminator
• Connection: OEM-specification plug-and-play connector
• Installation: No cable cutting required — fully reversible
• Fitment: Ducati Panigale 1199 / 1199 R / 1199 S (2012–2017)
• Intended use: Motorsport / closed-circuit race use only